Lee Precision Mold Double Cavity 50 Cal-320

Lee Precision Double Cavity R.E.A.L. (Rifling Engraved At Loading) Bullet Mold produces two .50 Caliber, 320 grain bullets for Muzzleloaders. Because of the unique cleaning action, this solid bullet loads easily even after many firings. When inserted into the muzzle, tiny scraping edges are swagged forward on each band. These fitting scrapers remove the fouling from the previous shot. A perfect bullet for hunters with heavy loads. The bevel base of the R.E.A.L. bullet contributes to greater accuracy. As the bullet exits the bore,the gas escapes equally around the perimeter of the base. Will not tumble. Includes Handles and Sprue Plate.

USE ONLY PURE LEAD

INCLUDES:

• Hardwood handles
• Hard anodized sprue plate
• Two Aluminum mold block halves
• Instructions/Load Data

NOTES:

• Bullet mold will be damaged & bullet will be poor quality unless lubricated. FS Reloading recommends Frankford Arsenal Cleancast Lead Fluxing Compound or Frankford Arsenal Drop out Bullet Mold Release and Lube Aerosol.
• The Lee Precision Melter 110 V is the best method of melting your metal. Heat control is simple & your best bullets are poured with the Lee Ladle.
• Before handling lead or case lube, FS Reloading recommends Tipton Vinyl Gloves
• For Load Data information try HODGDON Powder Co.

Lead Information:

• The following lead information is from the Lee Precision Modern Reloading 2nd Edition Book, Pages 119 & 120.
• For best results, bullet strength must be matched to breech pressure.
• Black Powder guns require Pure Lead.
• Target handgun loads should use Lead with 1% Tin. Tin makes bullet alloy more castable & harder.
• Lead with some wheel weights used for high pressure handguns.
• Use Wheel Weights for very light rifle loads.
• High Pressure Rifle loads use Linotype.
• Beware of Zinc! One part Zinc in 10,000 parts of Lead Alloy will ruin it's castability.

WARNING: Melting lead and casting lead objects will expose you and others in the area to lead which is known to cause birth defects, other reproductive harm and cancer.

USE STRONG VENTILATION

Lead contamination in the air, dust and on your skin is invisible. Keep Children and pregnant women away during use and until clean-up is complete. Risk can be reduced, BUT NOT eliminated, with strong ventilation. Washing hands immediately after use of these products before eating or smoking. Careful cleaning of surfaces and floors with disposable wipes, after lead dust has settled. Use lead-specific cleaner with EDTA or high phosphate detergent (such as dishwasher detergent). Bag wipes for disposal.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures

WARNING:

Ammunition reloading can be dangerous if done improperly, and should not be attempted by persons not willing and able to read and follow the instructions included with each product exactly.

• Always wear safety glasses when reloading and shooting.
• Ammunition loaded with these tools should be used in modern guns, in good condition.
• Children should not be permitted to reload ammunition without strict parental supervision.
• Primers and gun powders, like gasoline and matches, can be dangerous if improperly handled or misused.
• We do not accept responsibility for ammunition loaded with these tools, as we have no control over the manufacture and storage of components or the loading procedure and techniques used.