Lee Precision Carbide Full Length Sizing Die .45 Colt

The Lee Precision .45 Colt Carbide Sizing Die's solid carbide sizer ring is specially ground and polished with diamond wheels so no case lubrication is needed saving you time and money. Lee's exclusive contour grind sizes closer to the rim than any other brand of sizing die.

The collet held decapper is nearly unbreakable even if you miss-adjust it. And it is strong enough to decap military cases with crimped primers. The collet clamp accurately centers the decapper in the die. Should you over stress the decapper for any reason, it harmlessly slides up without breaking and is easily reset.

Includes:

• Carbide Sizing Die
• Custom fit plastic storage case

FEATURES:

• Decaps military cases
• Leaves no belt mark on your cases
• Nearly unbreakable collet held decapper
• Sizes closer to the rim than competing brands
• No case lubrication required saving you time and money

FITS:

• .45 Colt
• .45 Schofiled
• .455 Webley Mark II
• .454 Casull
  

Photo Note:

.45 ACP is shown, other calibers are similar.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures

WARNING:

Ammunition reloading can be dangerous if done improperly, and should not be attempted by persons not willing and able to read and follow the instructions included with each product exactly.

• Always wear safety glasses when reloading and shooting.
• Ammunition loaded with these tools should be used in modern guns, in good condition.
• Children should not be permitted to reload ammunition without strict parental supervision.
• Primers and gun powders, like gasoline and matches, can be dangerous if improperly handled or misused.
• We do not accept responsibility for ammunition loaded with these tools, as we have no control over the manufacture and storage of components or the loading procedure and techniques used.