Lee Precision Bullet Feed Kit 9mm to .365 Caliber, to .75 Long

The Lee Precision Bullet Feeder Kit automatically feeds 9mm-.365 (.65-75 long) bullets into the mouth of the bullet seating die. Aligns bullets more accurately and greatly increases production. Start by selecting the correct Bullet Feed Kit for your bullet diameter and length.

The feed die opening should be just long enough to freely feed your bullet. Do not select an excessively long feed die, as bullet tipping and misfeeds will result. This kit, along with the Lee Bullet Seat & Feed Die, fully automates the Lee Precision Pro 100 and Load Master presses only.

TROUBLE FREE SIMPLE OPERATION

INCLUDES:

• Bullet Feeder
• Large & Small Tubes
• Bullet Feed Die
• Bullet Feed Fingers
• Instructions

Features:

• Auto bullet feed
• Aligns bullets more accurately
• Fits: 9mm-.365 caliber bullets up to .60-75 long, Lee Precision Small Feed Tube, Lee Pro 1000 & Lee Load-Master Presses, Lee Precision Feed Die & Fingers #90888

Notes:

• To prevent tipping or misfeeds, select shortest kit, that will feed your bullet. Unusually long, short or oddly shaped bullets may require a special feed die. These are available factory direct at Lee Precision.

PHOTO NOTES:

• Bullets and bullet seating die shown in photos are for illustration porposes only and are not included. Bullets and bullet seating dies are sold separately.

Caution:

• This tool MUST be used with a Lee Bullet Feed & Seat Die. Attempts to use any other die will damage the bullet feeder. This die has a tapered end to release the bullet feed fingers, and is shortened to allow space for the fingers while crimping.
• DO NOT store press with carrier in full down position or fingers will take a set in the open position.
• DO NOT store press with bullet in the feed fingers or fingers will take a set in the open position.
• If the feed fingers take a set in the open position, they can be quickly repaired by placing them in boiling water.

Parts	Manual